Updating the Rainmaker to Version 1.07/10

Eurorack
#1

I have updated the screen without any problem.

but when i successfully update the latest jic file via quartus, the display on the rainmaker continue to display 1.07/9

Info (209060): Started Programmer operation at Sun Nov 12 13:57:30 2017
Info (209016): Configuring device index 1
Info (209017): Device 1 contains JTAG ID code 0x020F30DD
Info (209007): Configuration succeeded – 1 device(s) configured
Info (209018): Device 1 silicon ID is 0x16
Info (209044): Erasing ASP configuration device(s)
Info (209023): Programming device(s)
Info (209011): Successfully performed operation(s)
Info (209061): Ended Programmer operation at Sun Nov 12 13:57:41 2017

any idea?

#2

found Kamil explanation on Muff.

"
Unfortunately there was a quirk with the latest v10 FPGA update and it will still display v9 even if it was applied. Unfortunately the only way to correct this is to make another FPGA and screen update, which seems like a pain to put people through just to have the right number show up.

So if you’ve updated to v10 and it still shows v9, you’re probably good. Check the VERIFY checkbox in Quartus when updating. If it reports ok, then it worked."

1 Like