Problems with mixup

I’ve just plugged in my mixup to the intellijel 7u case. and i’ gm getting no signal?

Everything is plugged in as per the manual on page 9 with the chain out going to the 3 pin connector on the 2nd generation audio jacks. But there is no light on the mix up and no signal coming in or out.

Here is a second look.

Is your ribbon cable connected correctly?

Yes ribbon cable is correct. Figured it out though, the input signal was too low to register. Doh!

I can see in the photo you have something else connected to that audio output board via ribbon cable. You can’t have both. Either Mixup connects there, or your stereo line out 1u connects there.

1 Like