I just purchased a 62 HP palette and among other things, a USB power 1U module. This comes with a two-pin cable to be connected to the power board. The manual shows where the 5v connector is but is has 4 pins, not 2 like the cable. Furthermore, the cable can only be plugged into the top and bottom but not the middle (pins 1+2 or 3+4 but NOT 2+3). How do I plug this in correctly?
The manual shows that as two 5V connectors stacked on top of each other. You can’t plug into the middle pins because that would be bridging the two connectors:
1 Like
Those are two connectors side by side. Just plug into the top set of two or the bottom set.
1 Like
Thanks d4ydream and Danjel!
3 Likes