Scales dual mode

Eurorack
#1

Hi all, I’ve been trying to use scales In dual mode… so far so good, what I’d like to know is can I have the trig (in) act as a sample and hold for pitch (in), while still sending independent cv through shift (in) to out (b). Out (b) seems to ignore shift (in) as soon as I patch into trig(in). I have a sample and hold unit for the out (b).

Any advice on this will be much appreciated

P

#2

This has been discussed a bit in another thread but basically in DUAL mode both quantizers share a trigger. So if you want one to sample at a slower rate you would send that to your S&H then trigger it when desired.